Cord Drawn Curtain Tracks Instructions

Re attach track onto brackets and re hang curtains.

Cord drawn curtain tracks instructions.

Hook cord over the lug on carrier 2 to secure it. Pass the cord over the central bridge on slave master slide f twist cord to create a loop and hook over centre tab f pass cord over the top of the bottom pulley in opposite end pulley. If you re removing an old cord you can untie it. Then feed cord around and over the top pulley g pass cord back through ovelrap master slide.

Remove the curtain rod from the. 8conversion to one way draw right hand conversion drapes drawn from left to right 1 lay track face down on the floor. How to thread cord on curtain rails. Most curtain tracks do not have the mounting holes pre drilled.

Measure also the distance from the floor to the top of the curtain rod. How to fit new cord to curtain tracks take measurements. Replace sliders at each end. Fitting instructions for styletrack track if installing into plaster or wallboard where possible try and pick up a timber stud.

3 unhook cord from master carrier and allow to drop inside track. Measure the rod s length while it is still on the wall. Standard drill bits work fine on all aluminum tracks. Add those two.

Click here for how to mend it. To drill holes identify where the holes should be positioned and mark the track. Cord on overlap master carrier as original. Using a small bit drill pilot holes centered in the slot through the top of the track.

I have fitted a metal white curtain track with cord attachments and runners but finding it very difficult to correctly hang the curtains problem overlaper runner hope you can help pulling my hair out thanks. If unable to locate a timber stud use a suitable wall plug or toggle for hollow walls to hold your bracket. Remove the curtains from the traverse rods so you can access the cording. Once you have worked out were your track is going to go.

Holding the cords taut push carrier 2 as far to the left as possible. Curtain track features and how to install. First you ll want to remove the curtain along with the curtain hooks from the rod and carriers. Draw the cord until the right hand carrier 1 is as far to the right as possible.

Tension cord and tie off h. Then remove master carrier from the track. 2 pull track apart at the centre.